This app provides, using weather conditions and your engine configuration, a recommendation about jetting and spark plug to use for karts with Rotax Max EVO (Senior, Minimax, Micromax, Supermax, DD2 or Junior), which use a Dellorto VHSB 34 XS carb.
In order to get the weather values, the application can use the GPS to obtain the position and altitude, and the network connection to get the temperature, pressure and humidity from the nearest weather station. Nevertheless, the application can run without GPS and internet connection, in this case, the user has to give the weather data.
The application is made up of four tabs that are described next:
- Results: in this tab, the recommended main jet, needle position, air density and spark plug type values are shown. This data are calculated depending on the weather conditions and the engine configuration given in the next tabs. In addition, this tab lets to make a fine tuning adjustment to adapt to a concrete engine.
- Weather: you can set the values for current temperature, altitude, pressure and humidity. The values of this screen can be manually set or can be loaded by the application reading the data from the nearest public weather station (from the GPS tab).
- Engine: you can set in this screen the information about your engine, carburator and track, that is, the engine type (Micromax, Minimax, Senior, Supermax, Junior or DD2), the spark plug brand used, the needle type, the float/pilot jet combo, the floats height, venturi, oil mix ratio, airbox type (new or old model) and the track type.
- GPS: this tab allows to use the GPS to get the current position and altitude, and connect to an external service to get the weather conditions of the nearest weather station (temperature, pressure and humidity).
The application works with different measure units: inHg, mb, mmHg, hPa, atm for pressure, ºC and ºF for temperature.
The app is NOT VALID for Rotax Max engines before 2015. For these engines, you should install Jetting Max Kart.
|Jetting Max Kart for Rotax Max EVO|
|Jetting for Vortex RVS, RVX, RVXX, RVZ & RKZ Kart|
|Jetting for Maxter MXO, MXV, MXE, MXS & MXS2 Kart|
|Jetting for Husqvarna TC, TE & TX 2T|
|Jetting for IAME kart engines|
|Jetting for Yamaha KT100 Kart|
|Jetting for IAME KZ Kart|
|Jetting for Modena KK1, KK1R & MKZ KZ Kart|
|Jetting for Suzuki RM two strokes motocross, SX, MX or supercross, off-road race bikes - Setup carburetor without repair manual|
|Jetting for Kawasaki KX two strokes motocross, SX, MX or supercross, off-road race bikes - Setup carburetor without repair manual|
|Jetting for Yamaha YZ 2T motocross, SX, MX, enduro or supercross, off-road race bikes|
|Jetting for Honda CRF 4T motocross, SX, MX, enduro or supercross, off-road race bikes|
|Jetting for Honda CR 2T motocross, SX, MX, enduro or supercross, off-road race bikes|
|Kart Chassis Setup - Analysis and tuning|
|Air Density Meter & Density altitude calculator|
|Jetting for KTM SX, EXC, XC & MX 2T|
|Jetting CR125 Shifter Kart - Setup & tuning for Honda CR125 kart engines|
|Jetting TM Kart for KZ10 (B,C) & K9 (B,C) engines|
|Jetting Max Kart for Rotax Max|